Page 1 of 1

Since updating to 3.16, getting "Some commands were stopped"

Posted: Jan 19th, ’17, 23:23
by RobertJSawyer
Since updating from 3.13 to 3.16 on Windows 7 Pro 32-bit, I get the "ERROR. Some commands were stopped" message. The only module I have active is TextExpander, and I've made no change to my phrase file since the upgrade.

The message goes on to say, "Please check last edited commands and correct possible duplicate functions." I've checked the phrase file (the only text-expander abbreviations I use) and their are no duplicates or obvious syntax errors.

The message further provides a link for "Show error report," but clicking it does nothing. Is the report file actually stored somewhere? I couldn't find it in the Fastkeys program directory. Thanks!

Image

Re: Since updating to 3.16, getting "Some commands were stopped"

Posted: Jan 19th, ’17, 23:34
by Marko
Could you please send me your settings.fdb file to our support mail?

Re: Since updating to 3.16, getting "Some commands were stopped"

Posted: Jan 19th, ’17, 23:40
by RobertJSawyer
I just sent the requested file to: fastkeys.info

if there's a better email address, please let me know. :)

All best wishes!

Re: Since updating to 3.16, getting "Some commands were stopped"

Posted: May 7th, ’19, 13:10
by mrmcwn
Hi - I'm getting the same message. How was this issue resolved?

Re: Since updating to 3.16, getting "Some commands were stopped"

Posted: May 7th, ’19, 14:09
by Marko
You can send us your settings.fdb file and we will check.

Re: Since updating to 3.16, getting "Some commands were stopped"

Posted: May 8th, ’19, 17:37
by mrmcwn
Hi - I was able to get the error report to appear. One of my expanders ended with two commas. I changed this to a semicolon and the problem seems to be resolved. Thanks for your prompt reply though!